Introduction
1-6 Basler A500k Series
PRELIMINARY
1.4 Environmental Requirements
Temperature and Humidity
Housing temperature during operation: 0° C ... + 50° C (+ 32° F ... + 122° F)
Humidity during operation: 20% ... 80%, relative, non-condensing
Ventilation
Allow sufficient air circulation around the camera to prevent internal heat build-up in your system
and to keep the camera housing temperature during operation below the maximum shown above.
Provide additional cooling such as fans or heat sinks if necessary.
*
You can measure the inner temperature via the temperature register. The maximum
recommended inner temperature is 60° C (140° F).
Note that the camera components’ life time and the image quality are higher the
lower the temperature of the camera.
To Next Page
Loading...
