Inspection intervals - maintenance notes
Operation manual b maXX BM4100 (NWR)
Document no.: 5.04052.09 Baumüller Nürnberg GmbH
108
of 142
10.3
10.3.1 Periodic maintenance
m Environmental condition
m Voltage
m Mechanical parts
m Power supply
Check points Methods and criteria Inspection intervals
Daily Semi-
annu
-
ally
Annu-
ally
Check environmental temperature, humidity and
vibrations.
Check whether dust, oil or drops of water appear.
Visual inspection and measurement of the environmen-
tal conditions, comparison with standard values.
O
Check whether there are hazardous objects in the
vicinity.
Visual inspection O
Check points Methods and criteria Inspection intervals
Daily Semi-
annu
-
ally
Annu-
ally
Check the voltage of the power supply system and
the control circuits
Measurement and comparison with standard values. O
Check points Methods and criteria Inspection intervals
Daily Semi-
annu
-
ally
Annu-
ally
Are there any abnormal noises or vibrations? Visual and audio check O
Are there any loose screws? Tighten the screws. O
Are there any bent or damaged parts? Visual inspection O
Have there been any color changes due to over-
heating?
Visual inspection O
Are there any dust or dirt deposits? Visual inspection O
Check points Methods and criteria Inspection intervals
Daily Semi-
annu
-
ally
Annu-
ally
Are there any missing or loose screws? Replace the screws or, respectively, tighten them. O
Is there any deformation, cracking, damage or
color change on the device as a result of overheat
-
ing or aging?
Visual inspection O
Are there any dust or dirt deposits? Visual inspection O
To Next Page
Loading...
Need help?
General
