Safety
Operation manual b maXX BM4100 (NWR)
Document no.: 5.04052.09
13
of 142
2
2.4 Responsibility of the operating company
The device will be used in commercial areas. Thus, the proprietor of the device is subject
to the legal work safety regulations.
Along with the notes on work safety in these instruction handbook, the safety, accident
prevention and environmental protection regulations valid for the area of application of
this device must be complied with. Whereby:
m The operating company must inform himself about the applicable work health and safe-
ty regulations and ascertain, in a hazard assessment, any additional hazards that could
arise from the special working conditions in the use area of the device. These must
then be implemented in the form of instruction handbook for operation of the device.
m These instruction handbook must be kept accessible to personnel working with the de-
vice at all times in the immediate vicinity of the device.
m The specifications of the instruction handbook must be adhered to completely and
without exception.
m The device may only be operated in a technically faultless and operationally safe con-
dition.
2.5 Protective devices
The devices BM4135 and BM4145 meet the international protection IP10. BM4163 meets
the international protection IP00. All mentioned devices have to be installed into a suitable
control cabinet to meet the international protections required by the EN 61800-5-1, chap
-
ter 4.2.3.3. (IP30: only upper, horizontally surfaces; IP20: all other surfaces).
DANGER!
Risk of fatal injury from electrical current!
There is an immediate risk of fatal injury if live electrical parts are contacted.
Therefore:
m The device must be in operated inside of a control cabinet that provides protection
against direct contact of the devices and at least meets the requirements of
EN
61800-5-1, Chapter 4.2.3.3.
To Next Page
Loading...
Need help?
General
