Bay Networks BayStack 350 - Figure 3-36. Self-Test Screen after Resetting the Switch; Reset

Using the Console Interface
304376-B Rev 00
3-77
Reset
The Reset option (accessed from the main menu) allows you to reset the BayStack
350 switch without erasing any configured switch parameters.
Resetting the switch takes approximately 5 seconds to complete. During this time,
the switch initiates a self-test that comprises various diagnostic routines and
subtests. The LEDs display various patterns to indicate that the subtests are in
progress.
The results of the self-test are displayed briefly (5 or 10 seconds) in the Self-Test
screen (Figure 3-36
), which is followed by the Bay Networks logo screen
(Figure 3-37
).
Figure 3-36. Self-Test Screen After Resetting the Switch
Note:
The Self-Test screen remains displayed only if the self-test detects a
fatal error.
BayStack 350-24T Self-Test
CPU RAM test ... Pass
ASIC addressing test ... Pass
ASIC buffer RAM test ... Pass
Port internal loopback test ... Pass
Self-test complete.
kombk.book Page 77 Thursday, February 18, 1999 10:59 AM