304376-B Rev 00
E-1
Appendix E
Default Settings
Table E-1 lists the factory default settings for the BayStack 350 switch.
Table E-1. Factory Default Settings for the BayStack 350 Switch
Field Default setting Appears in this CI screen
BootP Request Mode BootP Disabled IP Configuration/Setup (page 3-7)
In-Band IP Address 0.0.0.0
(no IP address assigned)
In-Band Subnet Mask 0.0.0.0
(no subnet mask assigned)
Default Gateway 0.0.0.0
(no IP address assigned)
Read-Only Community String public SNMP Configuration (page 3-12)
Read-Write Community String private
Trap IP Address 0.0.0.0
(no IP address assigned)
Community String Zero-length string
Authentication Trap Enabled
Reset Count 1 System Characteristics (page 3-14)
Last Reset Type Power Cycle
Power Status Primary Power
sysContact Zero-length string
sysName Zero-length string
sysLocation Zero-length string
(continued)
kombk.book Page 1 Thursday, February 18, 1999 10:59 AM
To Next Page
Loading...