Bay Networks BayStack 350 - Configuring MultiLink Trunks

Quick Steps to Features
304376-B Rev 00
C-5
Configuring MultiLink Trunks
This section shows how to create a new MultiLink trunk or to modify an existing
MultiLink trunk (see Figure C-4
).
Choose MultiLink Trunk Configuration (or press t) from the MultiLink Trunk
Configuration Menu screen to open the MultiLink Trunk Configuration screen.
Figure C-4. Configuring MultiLink Trunks
Yes
No
No
Configure STP field.
Enable Trunk Status field
(see "MultiLink Trunking
Configuration Rules").
Configure trunk members
(see "MultiLink Trunking
Configuration Rules").
BS35050A
Are all
trunk members
configured?
Is trunk
STP Enabled?
Yes
Is trunk
Enabled?
Yes
No
Done
MultiLink Trunk
Configuration screen
Off-page reference
On-page reference
Key
kombk.book Page 5 Thursday, February 18, 1999 10:59 AM