60 Multifunction Control Panel
®®
This section describes the Phone page (see Figure 3.10).
Telephone Numbers
No. - This column shows the Telephone identifier number that will be used
instead of the Telephone label (Description), in some parts of the application. The
Telephone identifier number will also be used when programming the system
from a Keypad.
Telephone Number - This column is for the Telephone numbers that will be
utilized by the Digital Communicator and Dialler, and for Teleservice calls. This
field accepts a maximum of 20 characters (digits and pauses). Accepted values: 0
through 9, commas (,) for dialling pauses (e.g. between he prefix and telephone
number), and star (*) and pound (#).
Description - This field is for the User’s Name (maximum 16 characters).
Dialling
zz
zz
z Disallow tone check - Normally the Control panel will check for the Dialling
Tone before dialling. If there is no dialling tone, the Control panel will hang up
and retry. If the Disable Tone Check is enabled, the Control panel will dial
without checking for the dialling tone. This option is useful when the Control
panel is connected downstream to a switchboard with non-standard tones.
zz
zz
z DTMF Dialling- Normally the Control panel operates in touch-tone mode, as
it is faster than Pulse dialling. If touch dialling is not supported by the telephone
line, it will be necessary to enable Pulse dialling.
Phone Page
Figure 3.10 - Phone Page
To Next Page
Loading...
Need help?
General
