78 Multifunction Control Panel
®®
B Mode (Green) - This row will allow you to select the status the Partition
will assume when the Code makes a B Mode Arming request. The box will
indicate the selected mode (see the Mode section—top right of the ’Code
Page’). Refer to Table 3.1 for B Mode programming instructions.
Type - Double click this field to open the drop-down list and select one of the
following Code Types.
Main User - this Code type can perform all the operations allowed at the keypad.
User - this Code type allows:
a) Arm/Disarm operations (in accordance with programming)
b) Alarm memory reset
c) Overtime requests
d) Enabling/Disabling the Responder
Duress - this Code type can perform the same operations as a User Code,
and is used in the event of Duress (forced disarming). Duress Codes disable
the system and contemporarily activate the Dialler.
Patrol - this type of Code can disarm the Code Partitions for the programmed
Patrol Time. The Partition will rearm automatically when the Patrol Time ends,
or when the Patrol Code is entered again.
DTMF - this type of Code can access the system via touch-tone telephone.
Main User / Reset Call Queue - this type of Code is similar to the ‘Main
User’ Code except that, if this Code is used to disarm the system it will Clear
the Call Queue automatically.
And - Select this option if the Code is to be associated with an ‘AND’ operation
(
= ‘And’ attribute assigned).
Partitions with ‘And’ Codes/Keys will not disarm until all the respective Codes
and/or Keys are used within the programmed window (refer to ‘T. And Code’ in
the Partitions Page). This attribute is uninfluential for Stay or Away Arming.
Quick Arm
Code 22 can be used for the Quick Arm feature. This feature will allow the User
to Arm Code 22 Partitions from the Keypad by pressing and holding the ON key
for 3 seconds.
If the system is Armed from the Keypad in this way, the ‘Code Type’ will be
ignored.
For further information, refer to the ‘Operating from a Keypad’ in the ‘USER
MANUAL’.
Wireless Key Codes
The functions programmed for Codes 23 and 24 can also be activated by Wire-
less Keys (this facility is available to Control panels with VRX32-433 and Vector/
RX8 Receivers). For further information, refer to the description of the Wire-
less Keys Page in this section.
To Next Page
Loading...
Need help?
General
