Bentel Security KYO 4 M Installation Manual

81
®®
Section 3 - Programming from PC
Wireless Keys Page
If the Control panel is equipped with a VRX32-433 Receiver, it will be able to
manage up to 16 Wireless Keys. Each of the Wireless Key must be associated
with one of the two Codes available for the Wireless key facility (Code 23 or
24). The operating capacity of the Wireless Keys depends on the attributes and
access level of the selected Code. Figure 3.17b illustrates Wireless Keys Page.
The CEI 79-2 approval applies only when no more than 14 Wireless keys are used.
 No. - This column shows the Wireless Key identifier number, to be used
when programming the Wireless Key from a Keypad.
 Description - This field is for the Wireless Key label. The Application will use
the label as the Wireless Key Identifier.
 Serial No. - This field is for the 6 hexadecimal digit serial number (ESN) of
the Wireless Key. The ESN is printed on the Wireless Key label.
 Code - Select the Wireless Key Code (23 or 24).
Figure 3.17b - Wireless Keys Page
‘And’ Codes, for details refer to the Codes Page.
 Partitions 1, 2, 3, 4, 5, 6, 7, 8 - This field will allow you to enable the Key/
Card on the Partitions (Yes = Key/Card enabled).
 Del. - This field will allow you to delete Keys/Cards (X = Key/Card deleted).
Deletion will not be completed until the Program closes then reopens.

Bentel Security KYO 4 M Specifications

General

Brand	Bentel Security
Model	KYO 4 M
Category	Control Unit
Language	English