Bernette 79 - Needle Stop Up;Down and Free Hand System

12
bernette SEWING MACHINE WORK BOOK
1. Select the Straight Stitch #1.
2. Touch the Needle Up/Down button on the machine. Each
push of the button will raise or lower the needle.
3. To program the needle to stop in the down
position, select the Needle Stop Up/Down icon on
the screen.
4. Sew a line of stitching and stop in the middle of the fabric.
Hover is turned on by default and the foot will raise 2.0 mm
when the machine stops.
NOTE: Hover can be programmed from 1 mm (not raised at all)
to 6 mm in height.
5. Pivot to form at least 2 right angle corners and 2 additional
corners.
• When pivoting, use the bernette Free Hand System Knee
Lfter to raise the presser foot.
How do I lower the presser foot for sewing?
• There is no presser foot lift in the back of the machine--use the
button on the front of the machine to raise/lower the presser
foot.
• Press the Foot Control to lower the foot and begin sewing.
• Press/tap the Start/Stop button to hover and re-position your
work as needed.
Needle Stop Up/Down-bernette Free Hand System
HOW
Do you know how to:
• Use the bernette Free Hand System?
• Use the back-kick on the bernette Foot
Control to move the needle up or down?
Firm woven fabric, 4” x 6”, two pieces
80/12 Universal
Polyester or cotton embroidery thread
Center
Zigzag Sole (DA)-Dual Feed Engaged