27
bernette
SEWING MACHINE WORK
BOOK
Automatic Buttonhole-Corded
Corded Buttonhole
1. The button should still be in the back of the Buttonhole
Sole with Slide and the foot attached to the machine.
2. Fold the cord in half, place the loop over the hook at
the back of the foot.
3. Bring the two cord ends to the front of the foot and
insert them in the grooves at the bottom of the foot.
Tie the ends temporarily at the front of the foot.
4. Adjust the stitch width and length as desired.
5. Lower the presser foot and sew the buttonhole. The
buttonhole will sew over the cord, encasing it within
the stitches.
6. Pull the cord through the buttonhole until the loop
disappears in the bartack.
7. Pull the ends of the cord through to the wrong side of
the fabric using a hand stitching needle; knot or secure
with stitches.
8. Raise the foot and cut the thread
9. After sewing the buttonhole, raise the buttonhole lever
until it stops.
Wool-like fabric or heavy flannel, 8” x 6”
Lightweight tear-away stabilizer 4” x 6”
80/12 Universal
Polyester or cotton embroidery thread
As programmed
Buttonhole Sole with Slide (RJ)
3/4” (19 mm/30L) two-hole button
18" Narrow cord
(perle cotton, embroidery floss, etc.)
To Next Page
Loading...
