25
bernette
SEWING MACHINE WORK
BOOK
1. Attach Embroidery Sole (JK)
2. Place the stabilizer behind the fabric.
3. Select the Double Overlock Stitch #10, and sew for
about 1 1/2”.
4. Select the ‘i’ icon and select Balance; the right side of
display shows stitch pattern as programmed.
5. Use the Lower Multi-function (Stitch Length) knob
or the lower - icon to adjust the stitch -10; stitch for
another 1 1/2".
6. Use the Lower Multi-function (Stitch Length) knob or
the lower + icon to adjust the stitch +10; stitch for
another 1 1/ 2".
7. Clr returns the stitch to defaultl settings.
Balance
Firm woven fabric, 4” x 6”
Lightweight tear-away stabilizer 4” x 6”
80/12 Universal
Polyester or cotton embroidery thread
Default
Embroidery Sole-Sewing (JK)
Notes:
The Balance function is generally reserved for ne tuning
the stitch appearance, but is sometimes required because of
differences in fabrics and threads.
The Balance Function is used to troubleshoot and ne tune
stitches if they do not produce desired results with default
settings. Most often, this is caused by unusual fabrics or
threads.
HOW
Do you know how to:
• Fine-tune the stitch balance on your
machine?
-10
+10
Preprogrammed
Stitch
To Next Page
Loading...
