106
BERNINA Dual Feed
BERNINA Dual Feed
ATTENTION!
Only use «D» presser feet with cut-out at the center back.
If an incorrect presser foot is attached, the sewing computer
will not start with the dual feed engaged. An error message will
appear.
Switching On BERNINA Dual Feed
⦁
raise the presser foot
⦁
pull dual feed down until it engages
More «D» presser feet are listed in the enclosed accessories
catalogue.
With the BERNINA Dual Feed the top and bottom layer of fabric are fed
simultaneously, the even feeding enables perfect matching of striped and
checkered patterns.
Presser Feet Selection
Reverse pattern foot 1D
Zipper foot 4D
Switching Off BERNINA Dual Feed
⦁
raise the presser foot
⦁
hold dual feed on holder with two fingers, pull it down,
⦁
then push backward, slowly letting it slide upward
033805.51.04_2014-02_Manual_B710_EN
To Next Page
Loading...
