Bernina 710 - Calibrating Buttonhole Foot No. 3 A;Cleaning

52
Setup Program
Calibrating buttonhole foot No. 3A/Cleaning
⦁
attach buttonhole foot No. 3A
⦁
touch «Start/Stop»-button
►
the buttonhole foot No. 3A moves forward and backwards
►
the buttonhole foot No. 3A is calibrated and the sewing computer indicates
whether the calibration has been successful
The buttonhole foot No. 3A is matched to this sewing computer and should
only be used on this sewing computer.
⦁
touch «Calibration»-icon
1 Calibrating Buttonhole foot No. 3A
2 Cleaning the thread catcher
⦁
touch «Cleaning/Calibrating»-icon
⦁
clean the thread catcher according to the instructions
⦁
touch «Cleaning»-icon
1 2
033805.51.04_2014-02_Manual_B710_EN