70
Practical stitches
Automatic darning
Reverse pattern foot No. 1C
Buttonhole foot No. 3A
Simple darning program No. 22
Quick darning of holes or worn areas
Replaces threads along the lengthwise grain in all materials.
Preparation
⦁
hoop light weight materials in a round embroidery hoop (optional accessory)
►
the darning area stays evenly taut and cannot be distorted
Darning with reverse pattern foot No. 1C
Start sewing top left.
⦁
sew first row
⦁
stop sewing computer
⦁
press «Quick reverse»-button
►
the length is programmed
⦁
finish sewing the darning program
►
the sewing computer stops automatically
⦁
press the «clr»-button
►
the program is cleared
Darning with the buttonhole foot No. 3A
for darning worn and damaged areas
darning length max. 3cm
same procedure as with Reverse pattern foot No. 1C
Reinforcement
Use fine material or (adhesive) interlining as a backing.
If the darning becomes distorted
Correct with the Balance function (more about Balance-Function see
page 58).
033805.51.04_2014-02_Manual_B710_EN
To Next Page
Loading...
