Bernina 720 - Using Cord with the Buttonhole Foot #3

Buttonholes
107
> Pull the ends of the cord through to the wrong side of the fabric (using a hand stitching-needle), knot or
secure with stitches.
Using cord with the Buttonhole Foot#3
Prerequisite:
• The Buttonhole Foot#3 is fitted and raised.
> Insert the needle at the beginning of the buttonhole.
> Hook the cord over the pin at the back of the Buttonhole Foot.
> Pull both cords ends under the Buttonhole Foot to the back and place each a cord into a groove of the
sole.
> Lower the Buttonhole Foot.
> Sew the buttonhole in the usual manner.
> Pull the cord loop until the loop disappears in the bartack.