Bernina 720 - Sewing Double Overlock; Narrow Edgestitching

Practical stitches
90
ZigzagNo.2 is suitable for all fabrics. It can also be used for elastic seams as well as for decorative work. Use
darning thread for fine materials. When sewing satin stitch, it is recommended to select a dense short the zig
zag at a stitch length of 0.3–0.7 mm. The satin stitch can be used for appliqué and for embroidering.
Prerequisite:
• The edge of the fabric should lie flat and not roll.
> Fit the Reverse Pattern Foot#1.
> Tap «Practical Stitches».
> Select ZigzagNo.2 or Satin stitchNo.1354.
> Neither select too wide a stitch nor too long a stitch.
> Guide the edge of the fabric into the center of the presser foot, so that the needle goes into the fabric
on one side and over the edge into the air on the other side.
6.12 Sewing Double overlock
A double overlock seam is suitable for loose knits and cross seams in knits. When working with jersey, a
jersey needle should be used to prevent damaging the knit fabric. When sewing stretch materials, use a
stretch needle.
> Fit the Reverse Pattern Foot#1 or the Overlock Foot#2 (optional accessory).
> Tap «Practical Stitches».
> Select Double overlockNo.10.
6.13 Narrow edgestitching
> Fit the Blindstitch Foot#5 or Edgestitch Foot#10.
> Tap «Practical Stitches».
> Select Straight stitchNo.1.
> Place the left-hand edge against the guide of the Blindstitch foot.