Embroidering preparation
135
Selecting the stitch plate in the User Interface
After changing the stitch plate, you can check whether it can be used with the selected needle.
> Tap «Stitch Plate/Needle Selection».
> Select CutWork/Straight stitch plate.
Thread-up command
The machine must be ready for embroidery to bring up the bobbin thread.The bobbin thread can be brought
up in one step for a manual knotting. If no securing stitches are wanted, it is recommended to deactivate the
securing stitches in the Setup.
> Hold the upper thread.
> Push the button«Presser Foot Up/Down».
– The bobbin thread is brought up automatically.
13.5 Embroidery hoop
Overview Embroidery hoop selection
1 Hoop selection
To Next Page
Loading...
