Embroidering preparation
133
> Loosen the fixing screw of the needle using the screwdriver gray Torx.
> Pull the needle down.
> Hold the new needle with the flat side to the back.
> Insert the needle as far as it will go.
> Tighten the fixing screw of the needle using the screwdriver gray Torx.
Selecting the embroidery needle in the User Interface
After changing the needle, you can check whether it can be used with the selected stitch plate.
> Tap «Stitch Plate/Needle Selection».
> Select the fitted needle.
– If the selected needle is suitable in combination with the stitch plate, embroidering can be started.
– If the selected needle is not suitable in combination with the stitch plate, starting the machine is
automatically blocked.
Selecting the needle type and the needle size
Useful reminder function: To ensure that no information is lost, the needle type and the needle size can also
be saved on the machine. This means that the saved needle type and needle thickness can be checked at any
time.
> Tap «Stitch Plate/Needle Selection».
To Next Page
Loading...
