Bernina 720 - Centering or Opening Embroidery Motifs in the Original Position; Calibrating the Hoop

Setup Program
54
Centering or opening embroidery motifs in the original position
When the embroidery motif is opened on the machine, it is always centered to the embroidery hoop. If you
want the embroidery motif to be opened in its original position (defined by the BERNINA embroidery
software), the function «Centering the embroidery motif»must be activated.
> Tap «Setup Program».
> Tap «Embroidery settings».
> Tap «Centering the embroidery motif».
> Tap the switch in the right section.
– A previously moved embroidery motif which has been saved in the new position is opened in the
saved position after selecting.
> Tap the switch in the right section again.
– The embroidery motif is centered to the embroidery hoop.
Calibrating the hoop
The calibration of the embroidery hoop is the coordination of the needle to the center of the embroidery
hoop.
Prerequisite:
• The Embroidery Module is connected and the embroidery hoop with the appropriate embroidery
template is attached.
> Tap «Setup Program».
> Tap «Embroidery settings».
> Tap «Calibrating the embroidery hoop».
> Select the desired embroidery hoop and follow the instructions in the display.