Bernina 720 - Adjusting the Sewing Light; Calibrating the Display; Back to Default Setting

Setup Program
60
Adjusting the sewing light
You can set the brightness of the sewing light to meet your individual needs.
> Tap «Setup Program».
> Tap «Machine Settings».
> Tap «Screen Settings».
> Adjust the brightness of the sewing light in the lower section of the screen.
> Tap the switch to switch the sewing light off.
> Tap the switch again to switch the sewing light on.
Calibrating the display
Please find further information on this topic in the chapter attachment below troubleshooting at the end of
the instruction manual.
> Tap «Setup Program».
> Tap «Machine Settings».
> Tap «Calibrate Screen».
> Touch the crosses in sequence using the touchscreen pen.
Back to default setting
ATTENTION: Using this function will delete all individually made settings.
> Tap «Setup Program».
> Tap «Machine Settings».