Bernina 720 - Needle Stop Up;Down (Permanent); Changing the Stitch Plate

Sewing preparation
41
> To position the needle position to the right, push the button«Needle right»(2).
1 2
Needle stop up/down (permanent)
> To set the needle stop position permanently, tap «Needle Stop Up/Down».
– The machine stops with needle position down as soon as the foot control is released or the button
«Start/Stop» has been pushed.
> Tap «Needle Stop Up/Down» again.
– The machine stops with needle position up as soon as the foot control is released or the button
«Start/Stop» has been pushed.
Changing the stitch plate
The stitch plate is marked with vertical, horizontal and diagonal lines in millimeters (mm) and inches (inch).
These markings are helpful for sewing or precise top-stitching.
Prerequisite:
• The feed dog is lowered.
• The machine is switched off and disconnected from the power supply.
• The needle and presser foot are removed.
> At the marking on the rear of the stitch plate, push the stitch plate downwards until it tips.
> Remove the stitch plate.
> Place the openings of the new stitch plate above the corresponding guide pins and press down until it
clicks into place.