Bernina 720 - Moving the Module for the Sewing Mode; Grid On;Off; Locating the Center of the Embroidery Motif; Virtual Positioning of the Embroidery Hoop

Embroidering preparation
140
Moving the module for the sewing mode
The embroidery module can be positioned so that any sewing projects can be carried out even if the module
is connected.
> Tap «Hoop Indicator/Select Hoop».
> Remove the embroidery hoop.
P
> Tap «Move Hoop to the Left».
> Tap «Home».
> Tap «Sewing Mode».
Grid on/off
When the center of the hoop and the grid are displayed, the embroidery motif can be positioned more
exactly.
> Tap «Hoop Indicator/Select Hoop».
> To show the hoop center on the display, tap «Grid On/Off».
> To show the grid lines, tap «Grid On/Off» again.
> To hide the hoop center and the grid lines, tap «Grid On/Off» again.
Locating the center of the embroidery motif
The embroidery hoop is positioned so that the needle is exactly above the center of the embroidery motif or
the motif begin.
> Tap «Hoop Indicator/Select Hoop».
> To position the hoop so that the needle is placed exactly over the center of the embroidery motif, tap
«Center Motif».
> To position the hoop so that the needle is placed exactly over the motif start, tap «Center Motif» again.
Virtual positioning of the embroidery hoop
The embroidery hoop is automatically moved to the new position as soon as the embroidery motif is
repositioned. Therefore the icon «Virtual Positioning» is activated automatically and outlined in yellow when
an embroidery hoop is attached.
Prerequisite:
• The hoop is attached.
> Tap «Hoop Indicator/Select Hoop».