Bernina 720 - Securing; Securing in BSR1 Mode with the Button Start;Stop

BERNINA Stitch Regulator (BSR)
121
Prerequisite:
• The Slide-on Freearm Extension Table has been fitted.
• The knee lifter of the Free Hand System is attached.
> Lower the feed dog.
> Select the desired BSR Mode.
> To lower the presser foot, push the button «Start/Stop» or press the foot control.
> To start the BSR Mode, push the button «Start/Stop» again or press and hold the foot control again.
– A red light is lit on the BSR Presser Foot.
> Move the fabric to control the speed of the machine in the BSR Mode.
> To stop the BSR Mode, push the button «Start/Stop» again or release the foot control.
– The BSR Mode stops and the red light at the presser foot goes off.
BSR
> To deactivate the BSR Mode and to quilt without automatic stitch lengths, tap «BSR Mode».
1
11.7 Securing
Securing in BSR1 Mode with the button «Start/Stop»
Prerequisite:
• The BSR Presser Foot is fitted and connected to the machine.
• The BSR display opens and a BSR1 Mode is active.
> Lower the feed dog.
> Lower the presser foot.
> Push the button «Needle Up/Down» 2x.
– The bobbin thread is brought up.
> Hold the upper and the bobbin thread.
> Push the button «Start/Stop».
– Start the BSR Mode.
> Sew 5 –6securing stitches.
> Push the button «Start/Stop».
– The BSR Mode stops.
> Cut the thread.