Bernina 720 - Calibrating the Buttonhole Foot #3 A; Packing the Embroidery Module; Reviewing the Total Number of Stitches

Setup Program
62
Calibrating the Buttonhole Foot #3A
The Buttonhole foot with slide#3A is calibrated to the machine and they should only be used both
together.
Prerequisite:
• The Buttonhole foot with slide#3A is fitted.
• The needle is not threaded.
> Tap «Setup Program».
> Tap «Machine Settings».
> Tap «Maintenance/Updates».
> Tap «Calibrating the Buttonhole foot#3A».
> To start the calibration, push the «Start/Stop» button.
Packing the embroidery module
To pack the embroidery module into the original packaging without moving the embroidery arm manually,
the embroidery arm needs to be brought to its packing position.
Prerequisite:
• The embroidery module is connected with the machine.
> Tap «Setup Program».
> Tap «Machine Settings».
> Tap «Maintenance/Updates».
> Tap «Packing position».
> Follow the instructions on the display.
Reviewing the total number of stitches
The total number of stitches by the machine and the number of stitches since the last maintenance carried
out by a specialist BERNINA dealer are displayed.
> Tap «Setup Program».