Decorative stitches
99
Working with cord
A more distinctive and relief-like effect can be achieved when the pintucks are corded, which means that
they are sewn with an additional pintuck cord. Chose a pintuck cord that fits well into the grooves of the
selected pintuck foot. The cord must be colorfast and shrinkproof.
> Switch off the machine and disconnect it from the power supply.
> Remove the needle.
> Remove the presser foot.
> Remove the stitch plate.
> Open the hook cover.
> Pull the cord through the hook opening from the bottom and through the opening of the stitch plate.
> Replace the stitch plate.
> Close the Looper cover.
> Make sure that the cord slides through the thread slot of the bobbin cover.
> Place the spool on the spool holder.
> Check that the cord runs smoothly.
> If the thread doesn't glide smoothly at the hook cover, leave the hook cover open.
> If the hook cover is opened, deactivate the lower thread indicator in the Setup Program.
– The cord lies on the wrong side of the material and is hold/sewn over by the bobbin thread.
To Next Page
Loading...
