74 of 109
3. Remove the hook guard by loosening the screws on both sides
of the lower arm using a 2mm hex wrench, and sliding the hook
guard forward. The screws do not need to be completely removed.
4. Loosen the knobs of the lower shaft support. Then, slide the lower
support shaft out of the t-channel and off the machine.
5. Reattach the hook guard by sliding it back into place and tighten-
ing the two screws using a 2mm hex wrench.
6. The wide angle driver is now removed. Hoop arms can be reat-
tached to sew with standard hoops.
To Next Page
Loading...