78 of 109
5. Assemble the 4 nuts onto the threaded posts by hand. Allow them
to stay slightly loose. This will enable the adjustment of the support
wing assembly to the machine.
6. With the cap support wing assembly loosely installed on the wide
angle driver, install the driver onto the machine.
7. Using two of the thumb screws from the hoop arms, attach the
red driver to the x-carriage of the machine. Tighten them to n-
ger-tight, and then use a 6mm allen wrench to tight an eighth to
quarter turn more.
Do not over-tighten the screws as they are designed to break before
damage to the machine can occur.
To Next Page
Loading...