93 of 109
4. Slide the prepared cap onto the cap frame with the visor pointing
up and the frame going inside the cap. The bill should be pushed
against the bill-stop on the frame. The bill should also be relatively
centered on the frame. The centering mark on the bill-stop can be
used for reference.
The sweatband may not touch the vertical ridge of the frame. That’s
okay. Different caps have varying sweatband widths and not all will
appear the same when hooped.
5. The cap should ride over the two clip posts toward the bottom of
each side of the frame.
6. Press down on the bill to ensure that it is falling in the bill trough of
the cap frame. This will help keep the cap from slipping around or
off the frame when the cap is being sewn.
To Next Page
Loading...