BEUMER stretch hood® S
Operation
BA-6090103-EN
19.08.09
75
Parameters Function Note
016 With/without film surface
monitoring device
When entering the value "0", the film
surface monitoring device is de-
activated. When entering the value "1",
the film surface monitoring device is
activated.
020 Last film length The last film length is displayed in this
parameter.
024 Pallet under stretch hood This parameter defines the position
where the pallet stops in conveying
direction.
026 Gripper arms - transfer
film
This parameter defines the position of
the gripper arms for the transfer of the
film to the crimping bows. The film
must be slightly tensioned on all sides.
028 Stretch carriages - take
film
This parameter defines the position of
the stretch carriages for taking the film
from the gripper arms. In this position
the crimping bows must be able to
move into the opened film tube without
any problems.
030 Stretch sleds - take film This parameter defines the position of
the stretch sleds for taking the film from
the gripper arms. In this position the
crimping bows must be able to move
into the opened film tube without any
problems.
032 Stretch carriages - crimp
film
This parameter defines the position of
the stretch carriages for crimping the
film. The film must be slightly tensioned
on all sides.
034 Stretch sleds - crimp film This parameter defines the position of
the stretch sleds for crimping the film.
The film must be slightly tensioned on
all sides.
036 Lift hoist carts to relieve
the film
Once the film has been crimped, the
hoist carts are lifted. The value is to be
set so that the film can be sealed with-
out folds and tensile load.
040 Sealing time of the seal-
ing seam
The sealing time is calculated from the
parameter value multiplied by the factor
0.01 s.
042 Cool-down time of the
sealing seam
The cool-down time for the sealing
seam is entered in this parameter im-
mediately after sealing.
To Next Page
Loading...