BIFFI ICON 2000 - Page 10

10
© Copyright by BIFFI Italia. All rights reserved.
“ICON2000”
instruction and operating manual
2.2 STORAGE FOR A BRIEF PERIOD (less than one year):
2.2.1 INDOOR STORAGE:
- make sure that the actuators are kept in a dry place, laid on a wooden pallet and
protected from dust.
2.2.2 OUTDOOR STORAGE:
- make sure that the actuators are protected from the direct action of weather agents
(protection by a canvas tarp or similar cover);
- place the actuators on a wooden pallet, or some other raised platform, so that they
are not in direct contact with the ground;
- if the actuators are supplied with standard plastic plugs, remove them from the cable
entries and replace them with weatherproof plugs.
2.3 LONG PERIOD STORAGE (more than one year):
2.3.1 INDOOR STORAGE:
In addition to the instructions at point 2.2.1):
- if the actuators are supplied with standard plastic plugs, replace them with weatherproof
plugs.
- In case the actuator is provided with a lithium battery, remove it and store in dry and clean
place (see Sect. 618/3 chapt. M par. 3)
2.3.2 OUTDOOR STORAGE:
In addition to point 2.2.2):
- check the general conditions of the actuator, paying particular attention to the terminal
board and local display glass.
- In case the actuator is provided with a lithium battery, remove it and store in dry and clean
place (see Sect. 618/3 chapt. M par. 3)
Section 618/1 chapt. B
Section 618/1