Electric Actuator ICON2000/ICON2000AD
ADDENDUM E to INSTRUCTION HANDBOOK MAN 618
© Copyright by BIFFI Italia. All right reserved. Page
6 STORAGE AND PRE-INSTALLATION
6.1 Storage procedure
Not performing the following procedures will
invalidate the product guarantee.
Normally the optional extension for additional entry/entries or additional
electronic card are directly mounted on the base ICON2000/ICON2000AD by
BIFFI and leaves the factory in perfect condition. Under this condition the
general storage procedure as stated on the base INSTRUCTION HANDBOOK
MAN 618 must be applied.
When the above extensions are shipped separately for a field upgrading on
existing ICON2000/ICON2000AD unit this must be stored in a protected area
taking care that the explosion proof joints are well protected avoiding any
damage to the joint surfaces.
The standard plastic plugs used to protect the cable entry during the transport is
not explosion proof nor water proof, it just prevent the entry of undesired
objects during transport.
The extension for additional entry/entries or additional electronic card
maintain the same weatherproof degree of protection as the base
ICON2000/ICON2000AD. This condition can only be maintained if the
extension is correctly installed/connected on site and if it has been correctly
stored.
6.2 Checks to be performed before installation
Before to install the extension for additional entry/entries or additional
electronic card in an existing unit ICON2000/ICON2000AD the following
checks are recommended:
- the status of the joint surfaces
- status of the threads on the conduit entry
whether the enclosure holding the additional conduit entry is cracked or
broken.
To Next Page
Loading...
