Electric Actuator ICON2000/ICON2000AD
ADDENDUM G to INSTRUCTION HANDBOOK MAN 618
© Copyright by BIFFI Italia. All right reserved. Page
9
Repair works due to improper use will be charged at standard rates.
5 Manufacturer’s Liability
Biffi Italia declines all liability in the event of:
Use of product in contravention of local safety at work legislation.
Incorrect installation, disregard or incorrect application of the
instructions provided on the product nameplate and in the base
Instruction Handbook MAN 618 and relevant ADDENDUM G.
Modification of the product without Biffi’s authorisation.
Work done on the product by unqualified or unsuitable personnel.
6 STORAGE AND PRE-INSTALLATION
6.1 Storage procedure
Important
Not performing the following procedures will
invalidate the product guarantee.
Normally the optional extension for additional entry/entries or additional
electronic card are directly mounted on the base ICON2000/ICON2000AD
by BIFFI and leaves the factory in perfect condition. Under this condition
the general storage procedure as stated on the base INSTRUCTION
HANDBOOK MAN 618 must be applied.
When the above extensions are shipped separately for a field upgrading on
existing ICON2000/ICON2000AD unit this must be stored in a protected
area taking care that the explosion proof joints are well protected avoiding
any damage to the joint surfaces.
The standard plastic plugs used to protect the cable entry during the
transport is not explosion proof nor water proof, it just prevent the entry of
undesired objects during transport.
The extension for additional entry/entries or additional electronic card
maintain the same weatherproof degree of protection as the base
ICON2000/ICON2000AD. This condition can only be maintained if the
extension is correctly installed/connected on site and if it has been correctly
stored.
To Next Page
Loading...
