Vital Signs Monitor User’s Manual
Chapter 2-3
be disposed of in compliance with the guidelines regulating the disposal of
such products. If you have any questions concerning disposal of the
monitor, please contact us.
Magnetic and electrical fields are capable of interfering with the proper
performance of the monitor. For this reason make sure that all external
devices operated in the vicinity of the monitor comply with the relevant
EMC requirements. Mobile phone, X-ray equipment or MRI devices are
a possible source of interference as they may emit higher levels of
electromagnetic radiation.
Before connecting the monitor to the power line, check that the voltage
and frequency ratings of the power line are the same as those indicated on
the monitor’s label or in this manual.
Always install or carry the monitor properly to avoid damage caused by
drop, impact, strong vibration or other mechanical force.
When THERMAL CUT-OUT operates, the monitor will function
continually without any SAFETY HAZARD by using its rechargeable
battery. However, the battery is not being charged anymore. While the
battery is low the monitor will give both visible and audible warnings in 5
The American mains plug whose ground is in the same plug with its other
two cords is Hospital Only. The supply cord should be connected to the
sockets which are Hospital Only to achieve grounding reliability.
2.1.3 Note
Note
Put the monitor in a location where you can easily see the screen and
access the operating controls.
Keep this manual in the vicinity of the monitor so that it can be obtained
conveniently when needed.
The software was developed in compliance with IEC 60601-1-4. The
possibility of hazards arising from software errors is minimized.
This manual describes all features and options. Your monitor may not
To Next Page
Loading...
General