Biolight V6 - Setting Spo

Vital Signs Monitor User’s Manual
Chapter 6-4
a) Perfusion index (PI): PI is a value that indicates arterial pulse signal strength as the
percentage of pulsatile signal to non-pulsatile signal. The perfusion index allows
clinicians to place sensors on optimal sites.
b) Methemoglobin Saturation (SpMet): SpMet is a value that represents the
percentage of methemoglobin saturation within the blood.
c) Total Hemoglobin (SpHb): SpHb is a measure of the total hemoglobin
concentration in arterial blood.
d) Oxygen Content (SpOC): SpOC is a measure of the total oxygen content present in
the blood.
e) Carboxyhemoglobin Saturation (SpCO): SpCO is a value that represents the
percentage of carboxyhemoglobin saturation within the blood.
f) Pleth Variability Index (PVI): PVI is a measure of peripheral perfusion changes
secondary to respiration, or the PI amplitude modulation over a respiration, and can be
closely related to intrathoracic pressure changes.
6.5 Setting SpO
2
6.5.1 Opening the SpO
2
Menu
To open the SpO
2
Menu:
 Select ”SpO
2
” to enter【SpO
2
Setup】menu.
 Select ”Pleth” to enter【Pleth Setup】menu.
6.5.2 Setting Beep Volume
1. Select”SpO
2
” to enter【SpO
2
Setup】menu.
2. Set【Beep Volume】to【Off】or【1~5】.
6.5.3 Setting Scan Speed
 SpO
2
Scan Speed
1. Select”SpO
2
” to enter【SpO
2
Setup】menu.
2. Set【Scan Speed】to【6.25mm/s】,【12.5mm/s】,【25 mm/s】or【50 mm/s】.
 Pleth Scan Speed