Vital Signs Monitor User’s Manual
Chapter 6-5
1. Select “Pleth” to enter
【
Pleth Setup
】
menu.
2. Set【Scan Speed】to【6.25mm/s】,【12.5mm/s】,【25 mm/s】or【50 mm/s】.
6.5.4 Setting Average Time
The SpO
2
reading shown on the monitor is the average of data collected within a
specific time. The shorter the averaging time is, the quicker the monitor responds to
the change in the patient’s oxygen saturation level. Contrarily, the longer the
averaging time is, the slower the monitor responds to the change in the patient’s
oxygen saturation level, but the measurement accuracy will be improved. When a
critical patient is monitored, selecting shorter averaging time will help understanding
Select “SpO
2
” to enter
【
SpO
2
Setup
】
menu, Set
【
Average Time
】
to a desired
6.5.5 Setting Desat Limit
Desat Limit means that when the measuring value is lower than the limit, high
alarm will be triggered. Set the Desat Limit as follows:
1. Select 【Menu】 → 【System Setup】 → 【Machine Mainte】 → enter the password
to enter 【Machine Mainte】 menu.
2. Set
【
SpO2 Desat Limit
】
to a desired value.
6.5.6 Setting Wave Color
1. Select”Pleth” to enter【Pleth Setup】menu.
2. Set【Wave Color】to a desired color.
6.5.7 Masimo SpO
2
module setup
When using masimo SpO
2
module, You may need to do the following operations
Setting Sensitivity Mode
You can set sensitivity mode of Masimo SpO
2
module according to use condition.
Select
【
Sensitivity Mode
】
in the SpO
2
Setup menu with the options of
【
Max
】
,
【Max】: This mode should be used for the sickest patients, where obtaining a reading
To Next Page