Biolight V6 - Installing Recording Paper

Vital Signs Monitor User’s Manual
Chapter 11-2
1. Enter
【
Recorder Setup
】
menu through the above methods.
2. Set【Cycle Record Time】to【5 Sec】,【10 Sec】or【30 Sec】.
11.4.3 Setting Alarm Record
1. Enter【Recorder Setup】menu through the above methods.
2. Set
【
Alarm Record
】
to
【
On
】
or
【
Off
】
.
11.4.4 Setting Alarm Record Time
1. Enter【Recorder Setup】menu through the above methods.
2. Set【Alarm Record Time】to【5 Sec】,【10 Sec】or【30 Sec】.
11.4.5 Setting Gridding
1. Enter
【
Recorder Setup
】
menu through the above methods.
2. Set【Open Grid】to【On】or【Off】.
11.4.6 Setting Recorder Speed
1. Enter【Recorder Setup】menu through the above methods.
2. Set
【
Recorder Speed
】
to
【
6.25 mm/s
】、【
12.5 mm/s
】【
25 mm/s
】
or
【
50
mm/s】.
11.5 Installing Recording Paper
If the record paper runs out, please install the record paper as the following step:
1. Press both sides of the recorder door with one hand and pull outwards to open
the recorder door.
2. Put the recording paper into the recorder with the thermal side, which is
smoother up.
3. Close the door of the recorder, and pull some recording paper outside of the
paper out port.
Caution
 Must use the thermo-sensitive record paper; otherwise, it will lead to
recording failure, bad-quality record or damage of thermo-sensitive
printing head.