Biolight V6 - Page 44

Vital Signs Monitor User’s Manual
Chapter 6-3
2. “%” indicates SpO
2
unit while “*” indicates signal intensity. Details are as
the following table.
3. SpO
2
value
4. Pleth bar
5. Pulse Rate (obtained from SpO
2
)
Indicator of signal intensity
Description
“*”
The signal strength is low.
“**”
The signal strength is good.
“***”
The signal strength is best.
6.4.2 Masimo SpO2
The Masimo module is intended to monitor the SpO
2
, PR, PI, SpMet, SpHb, PVI,
SpCO SpOC of patients. The following figure shows the SpO
2
display screen, the
display on your monitor may be looked slightly different.
1. SpO
2
value;
2. SpO
2
unit;
3. PI (Perfusion Index) value and unit;
4. SpMet (Methemoglobin Saturation) value and unit;
5. SpHb (Total Hemoglobin) value and unit;
6. SpOC (Oxygen Content) value and unit;
7. SpCO (Carboxyhemoglobin Saturation) value and unit.
8. PVI (Pleth Variability Index) value and unit;
9. PR value
Note
 When one of the above parameters’ signals is weak, its label will fresh.
 Parameters Description
1
2
3
4
5
8
7
6
9