98 | Appendix A: Install the Barcode Scanner
1. If you have not already done so, turn off and unplug the BioStack.
2. Using a clean, cotton cloth moistened with alcohol, clean the side of the
BioStack where the scanner cable duct will be adhered.
3. Remove the adhesive backing from the duct. Attach the duct to the same side
of the BioStack as the scanner’s mounting bracket, and center the duct front to
back. Push the scanner cable into the duct.
4. Remove the adhesive backing on the scanner cable clip and attach the clip to
the back panel of the BioStack. Loop the excess cable into the clip, and plug
the cable into the scanner cable connection on the back panel of the BioStack.
5. Plug in and turn on the BioStack.
BioStack™ Microplate Stacker
To Next Page
Loading...
Need help?
General
