12 | Chapter 2: Installation
BioTek Instruments, Inc.
Unpacking and Inspecting the ELx800™
Important! Save all packaging materials. If the ELx800™ is
shipped to BioTek for repair or replacement, it must be carefully
repackaged, according to the instructions on pages 28 through 35
using the original packing materials (PN 7332062). The individual
packaging materials contained in PN 7332062 are listed in the
table below. Using other forms of commercially available packing
materials, or failure to follow the repackaging instructions may
void your warranty. If the original packing materials have been
damaged, replacements are available from BioTek.
The ELx800 and its accessories are securely packaged inside custom-designed shipping
materials. This packaging should protect the instrument from damage during shipping.
Inspect the shipping box, packaging, instrument, and accessories for signs of damage.
If the reader is damaged, notify the carrier and your manufacturer's representative. Keep
the shipping cartons and packing material for the carrier's inspection. The manufacturer
will arrange for repair or replacement of your instrument immediately.
Refer to the unpacking instructions and
Figures 1 through 4 on the following pages
when removing the instrument and its accessories from the shipping container.
See
Repackaging and Shipping the ELx800 at the end of this chapter for complete
shipping instructions.
Packing Materials PN
Shipping container 7332036
Shelf for power supply 7332063
Left foam end cap 7332060
Right foam end cap 7332061
2-Mil poly bag (ELx800) 98085
8 ½” x 11” bubble bag (power supply) 91083
Required Tools PN
Slotted and Phillips-head screwdrivers 98145
To Next Page
