System Startup | 41
ELx800 Operator’s Manual
System Startup
To turn on the ELx800™, press the on/off switch on the right side of the reader’s base. The
ELx800 will perform a System Test, displaying the screens shown below until initialization
is complete. During this period, all keys are inactive.
If the instrument fails the System Test, a chirp will sound, and an error code will display.
• Refer to
System Self-Test and Checksum Test in Chapter 4 for more
information.
• Refer to
Chapter 6, Troubleshooting and Error Codes to interpret error codes,
and
Chapter 1, Introduction for information on contacting BioTek Instruments’
Technical Assistance Center (TAC).
P o we r u p Sequence Vx.x x
I n it i a l izing...
B i o - T e k I n
trument
S y st e m Self-Test
IMPORTANT! Some ELx800 readers have custom
programmed software installed. Not all features of the
software discussed in this Operator’s Manual are available
on custom instruments.
Please contact BioTek’s Technical Assistance Center at 800-242-4685 if you have any
questions about the software on your reader.
To Next Page
Loading...
