–I–
Before Starting to Use the Unit
· When you use the unit, please observe the following notes listed on the rear of the body.
· For you to use it safely
1) When abnormal sounds, abnormal smell and smoke were confirmed, remove the battery and AC adapter
and stop the use.
2) Never use with hands that got wet, because doing so may cause damage, fire and electric shock to the
unit.
3) Never use it under the thunder. There is a possibility of receiving a thunderbolt.
4) Never use an AC adapter other than the one specified, because doing so may cause damage to the unit.
For static electricity protection, ground the unit by connecting the three cores if possible. Not grounding
the unit can damage it and the object measured.
5) Never use a battery other than the one specified, because doing so may cause damage to the unit.
When removing or installing the battery, be sure to do it after you turn off the unit and disconnect the
AC adapter.
6) When replacing the fuse, disconnect the AC adapter, open the battery cover on the back and remove
battery, and then take sufficient care to perform the replacement. Use 5A/250V fuse (IEC127-2 sheet 3,
slow-blow type).
Never use a fuse not specified because doing so may cause damage to the unit.
To Next Page
Loading...
Need help?
General
