Recorded Audio Channels
HyperDeck Shuttle HD can record up to 8 channels of PCM audio at a time. To select the
number of channels to record, expand the recorded audio channels list and select 2, 4 or
8 channels.
If the codec is set to H.264, you can also select 2 channels of AAC audio so you can upload
recordings directly to YouTube.
Storage Menu
Connected media will appear in the storage settings. Media 1 will list the name of the connected
SD card and media 2 will display any USB flash disk plugged into to the ext disk connector.
When using a USB hub, such as Blackmagic MultiDock 10G, the active disk is displayed.
USB Spill
If you are using a Blackmagic MultiDock 10G or similar to connect more than one drive via the
‘ext disk’ usb connection, turning USB spill on will ensure that recording will spill from one
external disk to the next.
Connect Network Drive
HyperDeck Shuttle can play HD media from Blackmagic Cloud and other network access
storage via Ethernet.
To connect to a network drive:
1 Using the search dial and set button, select connect network drive. A search dialog will appear.
2 Any servers found on your network will appear in a list. Highlight the drive using the search
dial and press set to select. To open a sub folder press set again, to select the sub folder,
hold down the set button.
3 Once your HyperDeck Shuttle is connected, you can select the network drive to connect
to. This drive will appear in the list of available network drives.
NOTE When playing from a network volume, HyperDeck Shuttle HD assumes guest
login on the server. Server access that requires a login and password is not currently
supported using the menu and set buttons but you can enter credentials using
HyperDeck Ethernet Protocol.
14Settings
To Next Page
Loading...
