Blackmagicdesign HyperDeck Shuttle HD - Page 29

Date and Time
Set your date and time automatically by ticking the box. When setting the date and time
automatically, your HyperDeck Shuttle HD will use the network time protocol server set in
the NTP field. The default NTP server is time.cloudflare.com, but you can also manually enter
analternate NTP server and then click on ‘set’.
If you are entering your date and time manually, use the fields to enter your date, time and time
zone. Setting the date and time correctly ensures your recordings have the same time and
date information as your network and also prevents conflicts that can occur with some network
storage systems.
Network Settings
Protocol
To control your HyperDeck Shuttle HD with ATEM switchers, or to control it remotely via
HyperDeck Ethernet Protocol, the HyperDeck Shuttle HD needs be on the same network as
your other equipment using DHCP or by manually adding a fixed IP address.
DHCP
HyperDeck Shuttle HD disk recorders arrive set to DHCP by default. The dynamic
host configuration protocol, or DHCP, is a service on network servers that
automatically finds your HyperDeck disk recorder and assigns an IP address.
TheDHCP is a great service that makes it easy to connect equipment via Ethernet
and ensure their IP addresses do not conflict with each other. Most computers
andnetwork switchers support DHCP.
Static IP
When ‘static ip’ is selected, you can enter your network details manually. When
setting IP addresses manually so all units can communicate, they must share the
same subnet mask and gateway settings.
29Blackmagic HyperDeck Setup