WPA2 Security
Sentry does not have a passcode by default. A passcode can be assigned from the Maps
Settings or Devices view. To assign a passcode,
1. Select More > Devices > Sentry > Sentry Network.
2. Tap the WPA2 Security Enabled toggle.
3. Tap New Passcode…
4. Enter a passcode between 8 and 63 characters. The WPA2 passcode may only
contain letters, numbers, spaces, and underscores. WPA2 passcodes are case
sensitive.
5. Tap Done.
6. Restart Sentry by holding the power button for two seconds to power it off.
7. Open the iPad/iPhone Settings app.
8. Select Wi-Fi settings and connect to Sentry using the new passcode.
Resetting a passcode (factory reset)
If you’re unable to connect to Sentry with WPA2 security enabled, perform a factory reset to
remove the passcode. To restore Sentry to factory settings,
1. Power Sentry on.
2. Press and hold the power button until the LEDs flash white (approximately ten
seconds).
3. Power Sentry on.
4. Open the iPad/iPhone Wi-Fi settings and connect to Sentry.
Battery
Sentry is equipped with a single rechargeable battery. The battery is not designed to be
removed or replaced. Sentry exclusively supports USB 5V (volt) 2A (amp) chargers. Sentry will
not charge if connected to a charger that delivers more power than it is designed to accept.
When charging, the Sentry power light is blue. It can take up to 12 hours to charge a depleted
Sentry battery. Sentry's battery percentage can be viewed in ForeFlight Mobile.
To check Sentry battery percentage
1. Connect your iPad/iPhone to Sentry.
2. Disconnect Sentry from the charger (if applicable).
3. Open ForeFlight Mobile > More > Devices > Sentry.
4. Scroll to the Battery field to view battery percentage.
To Next Page
Loading...
