WPA2 Security
Sentry Plus does not have a passcode by default. A passcode can be assigned from the Maps
or Devices view. To assign a passcode,
1. Select More > Devices > Sentry Plus > Sentry Plus Network.
2. Tap the WPA2 Security Enabled toggle.
3. Tap New Passcode…
4. Enter a passcode between 8 and 63 characters. The WPA2 passcode may only
contain letters, numbers, spaces, and underscores. WPA2 passcodes are case-
sensitive.
5. Tap Done.
6. Restart Sentry Plus.
7. Open the iOS device WiFi settings and connect to Sentry Plus using the new
passcode.
Resetting a passcode (factory reset)
If you’re unable to connect to Sentry Plus with WPA2 security enabled, perform a factory reset
to remove WPA2 security. To restore Sentry Plus to factory settings,
1. Power Sentry Plus on.
2. Press and hold the power button until the LED lights extinguish (approximately ten
seconds).
3. Power Sentry Plus on.
4. Open the iOS device WiFi settings and connect to Sentry Plus.
WARNING: Performing a factory reset on Sentry Plus will delete all Sentry Plus Track Logs.
Once factory reset is performed, it is not possible to restore Sentry Plus Track Logs.
RECOMMENDED: Import all Track Logs with ForeFlight prior to performing a factory reset.
To Next Page
Loading...
