Wi-Fi Client Support
If your aircraft is equipped with a wireless network, Sentry Plus can join the network and
provide its data through the aircraft’s wireless network. Sentry Plus will remember the aircraft’s
wireless network and automatically join in the future when powered on. Connecting Sentry
Plus to an aircraft network allows ForeFlight to receive data from Sentry Plus and the aircraft
simultaneously.
Exclusions
•
Capture portals are not supported.
•
Wireless networks that restrict UDP traffic are not supported.
•
Some weather data may not be available (see table on the following page).
Setup
To connect Sentry Plus to your aircraft’s wireless network, your aircraft’s wireless network must
be enabled and within range of your iOS device and Sentry Plus. To add Sentry Plus to the
aircraft wireless network,
1. Connect your iOS device to Sentry Plus.
2. Open ForeFlight Mobile.
3. Select More > Devices > Sentry Plus.
4. Select Wi-Fi Client Network.
5. Select your aircraft’s network from the list (if the aircraft’s network is hidden,
select Other… to manually enter the aircraft’s network name and password).
5. Enter a passcode if required.
6. Tap Join Network.
7. Sentry Plus will automatically reboot for the changes to take effect.
8. ForeFlight will re-establish communication with Sentry Plus to determine if the
network change was successful.
9. Connect your iOS device to the aircraft’s wireless network.
10.Open ForeFlight Mobile.
To Next Page
Loading...
