7.8.4 Example of a Correct Topology......................................................................................63
7.8.4.1 Control Unit of an lift Out of a Group.................................................................................63
7.8.4.2 Group of Two lifts in One Line ..........................................................................................64
7.8.4.3 Group of Two lifts in Three Lines ....................................................................................65
7.8.4.4 Group of Two lifts in Two Lines .......................................................................................66
7.8.5 Pin Assignments ...........................................................................................................67
7.8.5.1 Pin Assignment of D-Sub Plug Connector with 9 Pins .....................................................67
7.8.5.2 Pin Assignment of the RJ45 Socket Connector ...............................................................67
7.8.5.3 Pin-Assignment of the Open-Style-Connector..................................................................68
7.8.6 Node IDs of the CAN Components ...............................................................................68
7.9 Travelling Cable to the Car Top Box........................................................................69
7.10 Selection of the Frequency Inverter........................................................................70
7.10.1 Selection by CAN Bus ...................................................................................................70
7.10.2 DCP-Connection to the Inverter ....................................................................................70
7.10.2.1 Pin Assignment of DCP Plug Connector ........................................................................70
7.10.3 Wiring in Parallel with RVM-01.......................................................................................71
7.11 Installation of the Absolute Encoder.......................................................................73
7.12 Interconnection of the Group...................................................................................73
7.13 Data Lines to the Remote Diagnostics
System................................................................................................................................ 74
7.13.1 Analogue Telephone Line..............................................................................................74
7.13.2 ISDN.............................................................................................................................. 74
7.13.3 Ethernet......................................................................................................................... 74
7.13.4 LON............................................................................................................................... 75
7.14 Installation of the Emergency Call System.............................................................75
8 Commissioning Instructions.......................................................................................77
8.1 Preparation................................................................................................................78
8.2 Voltage-Test Module STM-02...................................................................................78
8.2.1 Prior to the First Switch-on ...........................................................................................78
8.2.2 Functional Description of Voltage Test Module STM-02..............................................79
8.3 Technical Tips Concerning the Control Unit..........................................................79
8.4 Checks before Starting the Control Unit ................................................................86
8.5 Switching the Mains Voltage....................................................................................88
8.6 Checking the Parameters of Control Unit and Drive Unit......................................88
8.6.1 Checking the Bus Lines.................................................................................................89
8.6.2 Checking the Bus Termination.......................................................................................90
8.6.3 Checking the CAN Parameters .....................................................................................90
8.6.4 Checking the DCP Connection.......................................................................................90
8.7 First Travel with Emergency Controls.....................................................................91
8.8 First Travel with Inspection Controls......................................................................92
8.9 Course of a Regulated Two Speed Travel (Summary)...........................................94
8.9.1 Disconnection Points for the High Travelling Speed (V3) ..............................................95
8.10 Course of a Direct Travel with DCP (Summary) ....................................................96
8.11 Commissioning of the Floor selector System ......................................................97
8.11.1 Installation of the Deceleration Switches .....................................................................97
8.11.2 Basic Settings................................................................................................................98
8.11.3 Read-in Travel with Absolute Encoder...........................................................................99
To Next Page
Loading...