C Setup Menu Quick Reference
Program Version: 88D2402B (14/02/2014)
Setup Menu
==========
+- Parameter
| |
| +- Lift data
| | * Top terminal floor
| | 2..127 [16]
| | * Bottom terminal floor
| | 1..126 [1]
| | * Type of lift
| | - Traction lift [Default]
| | - Hydraulic lift
| | * Drive type traction
| | - Single speed
| | - Two speed [Default]
| | - Variable frequency (CANopen)
| | - Variable frequency (DCP)
| | - Variable frequency (Parallel)
| | * CANopen Mode (profile)
| | - Position Profile Mode [Default]
| | - Speed Profile Mode
| | * Parallel Mode
| | - KEB binary [Default]
| | - Universal 1-out-of-n
| | - Universal 1-out-of-n (VN)
| | - Fuji binary
| | - Schindler VF11/22/33/44BR
| | * Drive type hydraulic
| | - unregulated [Default]
| | - LRV/iValve (Bucher)
| | - NGV (GMV)
| | - NGV A3 (GMV)
| | - AZFR (ALGI)
| | - AZRS (ALGI)
| | - regulated with DCP control
| | - BLAIN (SEV)
| | * DCP Mode (profile)
| | - DCP4+ (continuous brake distance feedback) [Default]
| | - DCP4 (Brake distance feedback before start)
| | - DCP3
| | - Bucher
| | - DCP-01
| | * DCP 16-bit mode
| | - off [Default]
| | - on
| | * Motor control
| | - Direct on line
| | - Star / delta
| | - Soft starter [Default]
| | - Frequency controlled
| | * Separate relevelling unit
| | - off [Default]
| | - up only
| | - down only
| | - up and down
| | * Drive upward using overtravel and relevelling
| | - off [Default]
| | - on
| | * Type of system
| | - Single lift [Default]
| | - Group lift 1
| | - Group lift 2
| | - Group lift 3
| | - Group lift 4
| | - Group lift 5
| | - Group lift 6
| | - Group lift 7
| | - Group lift 8
| | * Type of call system
| | - Collective controller [Default]
| | - PB - without call storage
| | - APB - with call storage
| | - Simple one button collective direction dependend
| | - Simple one button collective direction independend
135
To Next Page
Loading...