Böhnke + Partner bp308 - Page 134

| | * Floor selector type
| | - Floor selector emulation
| | - Absolute encoder (CAN) [Default]
| | - Using 4 switches impulse & level
| | - Using 6 switches 2 impulse & 2 level
| | - Absolute encoder emulation
| | - Absolute encoder AWG-05 (RS-485)
| | * Protective Circuit (SMZ)
| | - Off [Default]
| | - on, without blocking
| | - on, with blocking
| | - On, Test only
| | * Rated load
| | 100..65535 [630] kg
| |
| +- Terminals
| | |
| | +- Control Terminals
| | | |
| | | +- Input terminals
| | | | * Virtual input 1..48
| | | |
| | | +- Output terminals
| | | | * Virtual output 1..48
| | | |
| | | +- Call terminals
| | | | * Virtual input 1..48
| | | |
| | | +- Relay
| | | | * Virtual output 1..48
| | | |
| | | +- Remote monit. terminals
| | | |
| | | +- Monitoring input
| | | | * Monitoring Input 1..32
| | | |
| | | +- Monitoring output
| | | * Monitoring output 1..32
| | |
| | +- Terminals CAN 1
| | |
| | +- Terminals CAN 2
| | |
| | +- SLP-Terminals
| | |
| | +- SLP-Input terminals
| | | * SLP Virtual input 1..80
| | |
| | +- SLP-Output termin.
| | | * SLP Virtual output 1..80
| | |
| | +- Call terminals
| | | * SLP Virtual input 1..80
| | |
| | +- Relay
| | * SLP Virtual output 1..80
| |
| +- Floor Selector
| | |
| | +- APS1 settings
| | * Type
| | - User defined
| | - Rotary encoder 458 mm [Default]
| | - Rotary encoder 256 mm
| | - Limax-2 0.5 mm
| | - USP 0.1 mm
| | * Code sequence
| | - Clockwise [Default]
| | - Counter clockwise
| | * Resolution
| | 1..65535 [1024]
| | * Length
| | 1..65535 [458] mm
| | * Scaling function
| | - Disabled
| | - Enabled [Default]
| | * Offset
| | 0..4294967295 [0]
| | * Write configuration
| | - off [Default]
136